Winflex - NK250 Electric duct heater with thermostat - 2.4-1Un

Winflex duct heater with thermostat

Much more than just a heater, the Winflex round heater can be used on its own or in conjunction with a duct and extractor.

It allows heat to be distributed in a horticultural environment.

In conjunction with a controller, it enables you to pre cis room temperature.

Use in ventilation or air-conditioning ducts with a Winflex electric heater for powerful, constant heat distribution.

The Winflex fan heater is fitted with 2 thermostats to protect against unexpected overheating.
Basic protection with automatic restart at +50°C.
After cooling down, the thermostat automatically closes the Winflex heater control circuit. An emergency protection system with manual restart is provided.

Equipped with rubber seals, for ideal connection to ductwork.

Materials: Galvanized steel casing and box - Stainless steel heating elements .
Dimensions: Ø 249 - H 356mm - L 306mm - L1 226mm - W 150mm
Space between casing and duct outlet: 40cm

• Proper installation ensures uniform air distribution throughout the cross-section.
• The air filter protects the heating elements from pollutants and ensures correct operation. It should be positioned at the heater inlet.
• For use in large cultivation areas, several heaters can be connected in series.
• Three-phase heaters have a star connection.
• Integrated temperature controller.
  
  

Information - Winflex electric heaters for round air ducts NK250 2.4:

• If you use the speed control option, the air flow through the heater must be at minimum.
• If the fan is not running, the power supply to the Winflex heater must be switched off.